6-Cell Digital LED Battery Meter
This 6-cell battery meter plugs into the balance connector on your battery, and reads out the voltage of each cell in the pack on an LED display. It does this by cycling through each cell every 2 seconds. This meter shows only the number of cells in your pack. After it goes through all the cells, it will show the voltage level of the entire pack before it starts over with cell number 1.
The input connector has a standard 2.54mm (0.100 inch) spacing, and will work with most batteries, or any other battery that has a balance connector with 0.100 inch pin spacing. Our adpater may be used to convert for Thunder Power and others requiring 2mm spaced pins.
The meter features reverse polarity protection, so if you hook it up backwards it will not be damaged, just flip the connector over and try again.
The meter is powered from the first two cells in the pack, so it can be used to read 2-cell, 3-cell, 4-cell, 5-cell or 6-cell battery packs. The meter can also be used on batteries with more than 6 cells by simply plugging it in at the bottom edge of the connector to read the first 6 cells, then move it up higher on the connector as required to read the remaining cells in the pack.
Witrh an accuracy of + or - 0.02 volts per cell it is perfect for checking the general condition of a battery, balance of the individual cells, and state of total charge.